Skip to main content


Allow command line recall for READ commands.


[Miscellaneous]    LineRecall=n

n is either 1 (true) or 0 (false). The default value is 1.


When LineRecall is enabled (n = 1), both READ commands and command prompts can use the line recall feature. When not enabled, only command prompts can use line recall.

Changing This Parameter

On the Compatibility page of the Management Portal (System Administration > Configuration > Additional Settings > Compatibility), in the LineRecall row, click Edit. Select LineRecall to enable this setting.

Instead of using the Management Portal, you can change LineRecall in the Config.MiscellanousOpens in a new window class (as described in the class reference) or by editing the CPF in a text editor (as described in the Editing the Active CPF section of the “Introduction to the Configuration Parameter File” chapter in this book).

To change this parameter for a single process only (as opposed to instance-wide), use the LineRecall()Opens in a new window method of the %SYSTEM.ProcessOpens in a new window class. See the class reference for details.

FeedbackOpens in a new window