Settings for the Email Outbound Adapter
The outbound email adapter has the following settings:
|Basic Settings||SMTP Server, SMTP Port, Credentials|
|Connection Settings||SSL Configuration, SSL Check Server Identity|
|Additional Settings||Recipient, Cc, Bcc, From, ContinueIfInvalidRecipient|
The remaining settings are common to all business services. For information, see “Settings for All Business Services” in Configuring Productions.
Specifies a comma-separated list of email addresses to add to the Bcc: list of each mail message sent.
Specifies a comma-separated list of email addresses to add to the Cc: list of each mail message sent.
If selected, the adapter continues to send the message if one or more of the recipients have an invalid address.
The ID of the production credentials that can authorize a connection to the given server. For information on creating production credentials, see Configuring Productions.
The default From: address to put in mail messages. May be overridden by the business operation implementation code.
Specifies a comma-separated list of email addresses to add to the To: list of each mail message sent.
The port on the SMTP server to send mail to. The default value is 25.
The IP address of the SMTP server to send mail to. (Note: the timeouts for connecting and sending mail can be more than 10 minutes).
The name of an existing TLS configuration to use to authenticate this connection. Choose a client TLS configuration, because the adapter initiates the communication.
To create and manage TLS configurations, use the Management Portal. See InterSystems TLS Guide. The first field on the Edit SSL/TLS Configuration form is Configuration Name. Use this string as the value for the SSLConfig setting.
Generally, when you specify a value for this setting, outbound email opens a socket on default port 465 and uses SMTP over TLS. However, the SSL Config setting also supports the server interaction described in the RFC3207 standard. Specifically, you can enable the system to initiate the connection by opening a standard TCP socket and then switching to a TLS connection on the same port. The system achieves the switch by issuing the issue the STARTTLS command. To enable this special type of connection, you include an asterisk at the end of the SSL Config value, for example, MySSLItem*. The default SMTP port in this case is 25.
SSL Check Server Identity
When connecting to a POP3 or SMTP server via TLS, the server name in the certificate must match the DNS name used to connect to the server. This match is based on the rules in section 3.1 of RFC 2818.